Cutting Machine To Buy The Following Points

- Jun 28, 2017 -

  Cutting machine to buy the following points:

  First, cutting precision

  The general requirements for the construction industry category are under the Biong 5mm. But for the automotive reflector class requirements in the Biong. Olmm. The cutting precision which each machine manufacturer can provide is generally in Biong. 2mm below, but this can not be light to see the introduction of product specifications, in the acceptance should be a complete set of test cutting precision procedures, to measure the actual cutting precision of the product, we generally have more than 10 test samples. Through testing, we can fully grasp the flatness of the cutting platform and control the level of synchronization control system.

  II. Cutting speed

  In order to meet the cutting accuracy of the premise that we can talk about speed, because the cutting platform is short, with the eyes difficult to determine whether the highest speed, we can use the cutter servo drive matching software simulation function to see whether the speed of the motor to achieve the highest. In the test cutting speed without real cut, increase the speed of acceleration. The axes can be tested separately or simultaneously.

  Three, automatic typesetting optimization function

  On the edge of the cutting machine, taking into account the processing costs and the particularity of the work of the book, generally will not arrange a high degree of people to do, this requires the operation of cutting machine to be simple, easy to understand, not too complex, otherwise it will be able to afford the machine can not afford the embarrassing situation It is best to avoid the defect function, because the domestic floor glass sometimes have bad products. Special-shaped cutting graphics library to be more flexible, should make CAD graphics can also participate in typesetting.

  IV. EASY Maintenance

  /signals and mechanical sensors are not equipped with too much, unnecessary switches and indicators as far as possible, because once the machine on a device failure will affect the use of cutting machine, parts less fault probability is low, wiring also less, easy to find fault and replacement parts, the best screen can debug the state of the/signal. Maintenance costs are an important factor that must be considered when purchasing a machine.

  V. Energy Saving

  In the same can complete the cutting size requirements, the choice of energy-saving cutting opportunities for enterprises to bring many benefits. One is to protect the environment, save energy, the second is to save the day-to-day expenses of enterprises.


Related Products